Specifications

Surface Preparation
The concrete surface must be clean and free of all loose material, oil residue, sealers or paints.
Clean thoroughly by using a pressure washer with a degreaser or stripper if necessary. Etch the surface using a 1-4 acid solution.
Rinse clean and neutralise.

Mixing Instructions
In a clean 20 litre pail measure 4.75 litres of clean water. Using a drill with a mixing wand, slowly add the dry Patch It to the water as you are running the mixing wand. Once you have added all the material, continue to mix thoroughly for 2 minutes to a plastic consistency with no lumps. Smaller portions use enough water to mix to a plastic consistency.

Application Instructions
Patch & leveling:
Start by misting the surface with water, (surface should be damp only, no standing water) and then apply the Patch It compound. Screed where necessary, smooth with a round edged fresno or pool trowel, keeping all tools clean and moist, and finish as desired. If a more uniform surface is desired, coat the entire surface with Re Coat.

Note: If the area to be patched is thicker than 1", two or more applications may be necessary. Wait until the first application is dry, and then reapply.

Coverage
20.4 kg unit will cover 2.25 square meters at 6 mm thick.